Bissell 33N7 warranty Clearing clogs from the dirt cup, Maintenance and care

Maintenance and care

Replacing the dirt cup HEPA media & cleaning the foam filter continued

3.The dirt cup foam filter is located between the bottom of the dirt cup and the HEPA media filter. Once the HEPA media filter has been removed, the foam filter can then be removed and cleaned or replaced as needed. To clean the foam filter, wash with warm water and a mild detergent. Be sure to air dry completely before replacing this filter in the dirt cup.

4.To re-install the filters in the dirt cup, turn dirt cup upside down and replace the foam filter. Then replace the HEPA media filter by inserting the tabs on the back of the filter into the slots on the bottom of the dirt cup and snap the filter back into place.

Clearing clogs from the dirt cup

1.To clear clogs from the dirt cup, remove the top cover and set aside.

2.Empty the dirt into a garbage container.

3.Reach down into the dirt cup cyclone chamber to clear any dirt or debris from the cyclone and empty into a garbage container.

4.Remove the dirt cup, HEPA media filter and foam filters; set aside.

5.Remove any dirt or debris from the cyclone chamber opening.

6.If the holes in the cyclone appear to be clogged, place the cyclone chamber opening underneath running water and allow water to run through the holes in the cyclone to clear any clogs. Be sure to allow the entire dirt cup assembly to dry completely before replacing the dirt cup HEPA media filter and foam filters.

3.

4.

3.

5.

Cyclone

Chamber

Opening

w w w . b i s s e l l . c o m

116