How to use this guide
This User’s Guide has been designed to help you get the utmost satisfaction from your BISSELL® Upright Vacuum Cleaner. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling your vacuum cleaner.
Pay particular attention to the assembly diagram, assembly instructions, and part names.
Locate and organize all parts before assembly. Familiarize yourself with the parts and where they go. Following this User’s Guide will greatly enhance your ability to get the most performance from your BISSELL® Upright for many years.
How to put it together
The only tool you’ll need to assemble your vacuum cleaner is a Phillips head 
screwdriver.
WARNING: Plastic
film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
Attach Vacuum Body to Powerfoot
1. Place Powerfoot on floor with Connector Tube in vertical position. Place Bag/Body Assembly over Connector Tube as shown. Stand behind cleaner and push down SLIGHTLY on top of Bag/ Body Assembly until you hear a click.
2. Push long bolt through bottom hole on FRONT of Connector Tube. Place nut over end of bolt and hold in place while
tightening bolt with a phillips head screwdriver. NOTE: If bolt will not go through hole easily, repeat step 1.
3. Place Powerfoot and Bag/Body Assembly
on floor or other 
stable surface. Place
Metal Handle into recess on
back of Bag/Body Assembly as shown.
Align Carrying Handle over screw holes in Bag/Body Assembly.
4. NOTE: Lower Cord Wrap must point toward BOTTOM of cleaner.
5. Install four (4) screws through Carrying Handle and one (1) screw through Metal Handle as shown. Tighten all the screws. Do not overtighten - product damage may result.
6. Attach Hose and Tools. To attach Hose with Wand,
open Tool Door on top cover.
Insert end of Hose into Hose Port and
fit tabs into notches. Turn clockwise to lock. Press Hose into
Hose Clip. Route 
Hose over top of
cleaner, through
Hose Hanger on front of
Handle. Place end of Wand
over
Attach Tools to caddy in their positions
7. as shown.
4
