Replace Drive Belt
Replacement Belts
Use only BISSELL® Replacement Belt Style 2 (#3215P) in your Upright Vacuum Cleaner. You may purchase these belts from your retailer.
To locate a retailer near you, or to place an order using Visa, MasterCard, cheque or money order call:
BISSELL Customer Service
Monday - Friday
8:00 A.M. - 4:30 P.M. (E.S.T.)
1.With Rotating Floor Brush removed from vacuum cleaner, stretch old belt to clear Motor Pulley, and remove belt. Discard.
2.Place new Drive Belt over Motor Pulley and stretch other end over crown of Rotating Floor Brush.
3.Place belt end of Rotating Floor Brush into its slot and hold it in place with your left hand, while slowly pulling opposite end of brush down into its slot with your right hand.
4.Turn Rotating Brush by hand several times in direction of Motor Pulley. If properly installed, Drive Belt will centre itself on Rotating Brush crown.
5.Position Brush Cover Tabs in the four Brush Cover slots along front of Powerfoot, and snap Brush Cover into place.
Replace Lightbulb
Replacement Bulb
Use only BISSELL® Replacement Bulb
BISSELL Customer Service
Monday - Friday
8:00 A.M. - 4:30 P.M. (E.S.T.)
1.Unplug unit from electrical outlet.
2.Remove Cleaning Selector and Floor Surface Selector from Top Cover by grasping Selectors firmly and pulling straight up.
3.Place Handle in Upright position and turn vacuum cleaner face down on floor.
4.Insert a blade type screwdriver into four slots on underside of Powerfoot and pry outward on sides of Top Cover to unsnap internal latches.
5.Return vacuum cleaner to Upright position on floor and push Handle Release Pedal with foot to lower the Handle to Low Cleaning Position.
6.Lift Top cover from Powerfoot (If Vacuum Hose is attached to Hose Port, remove by turning counterclockwise and lifting up).
7.Gently work bulb from side to side while pulling up. Do not squeeze bulb too firmly with fingers or it may break and injure you.
8.Insert new bulb, pushing gently until it is firmly seated in socket.
9.Realign Top Cover to Powerfoot, making sure opening under Tool Door fits over Hose Port. Press Top Cover downward until you hear all four internal latches snap into place.
Test Top Cover for tightness by pulling up on it.
10.Replace Cleaning Selector and Floor Surface Selector by pushing them on firmly.
8
