Maintenance and care
Belt removal and replacement
1.Turn off the machine and unplug it from the outlet.
2.Remove the dirty and clean water tanks from the base of the machine.
3.While standing behind the unit, lay the unit on its’ side (cord side up)
4.Looking at the bottom of unit, find the back center of the brush carriage where the carriage latch is located. It is between the brush assembly and the front wheels.
5.Pull brush carriage towards you with one hand until it stops, then pinch the carriage latch with other hand while pulling the carriage towards you. The carriage should swing out to access belt cover.
6.Remove three screws from cover. Lift and remove to access brush carriage.
7.Turn the belt inward towards the large pulley while lifting out.
8.Place new belt over small pulley first and then slip the belt over the large pulley.
9.Replace the brush carriage and screws.
10.Push brush carriage back into place making sure the carriage latch locks back into place.
WARNING:
To reduce the risk of fire, electric shock, or injury,turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting.
3.
4.5.
6A.6B.
7.8.
9.10.
14 w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
