Bissell 58K5 warranty Clearing clogs, Cleaning the upper tank, Remove the brush from the belt

Maintenance and care

Maintaining TurboBrush™ Pet tool continued

3. Remove the brush from the belt and 4.

clean debris.

4.Replace the brush inside the belt and place ends into slots on sides as shown.

5.Reposition top cover making sure to line up inside tab at the front with the open-

ing on the cover. Twist collar until open-
ing is at the bottom to lock into place.	5.

Clearing clogs

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs.

1.Unplug the vacuum from electrical outlet.

2.Empty dirt container.

3.Check upper tank for build up or clogs.

4.If you notice a clog in the upper tank, remove the inner cyclone (see section "Cleaning the upper tank" below).

5.Grasp the hose wand and separate it from the hose wand base. Check for a clog in the base, the wand or in the hose.

6.Remove the Twist ‘n Snap hose from the vacuum by turning to the left. Straighten the hose and unclog with a long, narrow object such as a broom handle.

7.If the clog persists, follow the instructions for "Checking the rotating floor brush and drive belt" on page 10 and inspect the air pas- sageway for obstructions.

Cleaning the upper tank

5.

2.

1.

1.	Grasp the inner cyclone and twist to the
	left until the locking tabs stop the rotation.
	Pull down from the upper tank to remove it.
2.	Wipe out the inside of the upper tank and	3.
	the inner cyclone with a damp cloth moist-

ened with water or a mild cleaning solution.

3.If you desire to thoroughly clean the fil- tration disk located in the upper portion of the inner cyclone, hold the bottom of the cyclone and turn filtration disk to the right and pull up to remove.

12w w w . b i s s e l l . c o m