Assembling your vacuum
Tool required: Phillips screwdriver
1.Slide upper handle onto lower handle. Insert one screw into hole marked with an arrow and tighten until snug.
2.Attach hose by lining up the tabs on the
collar with the corresponding notches on | 1 |
the back of the vacuum as shown. Turn clockwise to lock the hose into place.
3.Wrap the hose by routing it down and into the lower hose clip then up and over the top of the handle. Insert the hose wand fully into the hose base.
Note: It is important that the hose is fully inserted into the base for the suction air to be directed properly to the foot during floor vacuuming.
4.Store TurboBrush on the front of the handle by aligning the slot at the bottom with the tab and snapping into place.
5.Place crevice tool inside telescoping extension wand. Store tools on vacuum as shown.
CAUTION:
Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.
2
34
w w w . b i s s e l l . c o m
5
8 0 0 . 2 3 7 . 7 6 9 1 | 5 |
7/25/06 12:42:23 PM
