Bissell 6592, 3545 warranty Cleaning Pre-Motor & Post-Motor Filters, Replace Drive Belt

Unplug cleaner from electrical outlet.

Cleaning Pre-Motor & Post-Motor Filters

Use only BISSELL Replacement Filters in your BISSELL vacuum.

Filter Kit (#203-1089)

Style 7 Post-Motor Filter Set 2 pack (#3099)

Style 7 HEPA Post-Motor Filter (#32076)

1. Unplug vacuum from electrical outlet.

The Pre-Motor Filter, located in the bottom of the bag compartment, protects the motor

2. from dirt particles. If filter becomes dirty, lift out filter and clean.

The Post-Motor Filter assists in the filtration process to return clean air to the room. To

3. remove this filter, open the door on the side of the cleaner. Grasp filter and pull it straight out.

Note: Select Models come with a white, pleated HEPA Media Filter. This filter is not washable and must be replaced.

4. The filters may be hand washed in cold water with mild detergent, then air dried.

5. Reposition filters when completely dry.

Check Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner’s Rotating Floor Brush and Drive Belt regularly for wear or damage. You should also clean the brush and brush ends of string, hair, and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.

1. Unplug vacuum from electrical outlet.

2. Place handle in Low position and turn vacuum over so bottom side is up.

3. Remove the five screws as shown with a screwdriver. Lift the Brush Cover off.

4. Grasp Rotating Floor Brush at both ends and lift.

Clean strings, hair and other debris from Rotating Floor Brush,

5. paying particular attention to brush ends.

6. Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.

7. Check Drive Belt carefully for wear, cuts or stressed areas. Replace if worn.

8. Check Air Passageway for obstructions. Remove debris from this area.

Replace Drive Belt

Pre-Motor	Post-Motor
Filter	Filter

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

WARNING:

To reduce the risk of injury from moving parts, turn off vacuum and disconnect Power Plug from electrical outlet.

Brush

Cover

Motor

Pulley

Air

Passageway

Use only BISSELL Style 7 Replacement Belts (#32074) in your

BISSELL vacuum.

1.

With Rotating Floor Brush removed from vacuum cleaner (Steps 1-4 of

2. Check Rotating Floor Brush and Drive Belt), grasp old Drive Belt and remove from Motor Pulley. Discard old Drive Belt.

	3.	Place new Drive Belt over Motor Pulley and stretch other end over Rotating
		Floor Brush in the space between the bristles.
	4.	Place ends of Rotating Floor Brush down into slots on sides as shown.
	5.	Turn Rotating Floor Brush by hand several times in direction of Motor Pulley. If properly
		installed, Drive Belt will center itself.
8	6.	Reposition Brush Cover and five screws. Tighten screws securely. Make sure end of
		Brush Cover is snapped into place.