Bissell 6594 Post-Motor Filter, Cleaning The Inner & Outer Circular Filters, with damp or wet

Cleaning The Inner & Outer Circular Filters

Use only BISSELL Style 10 Replacement Filters in your BISSELL

PowerForce Bagless.

1.Unplug the cleaner from electrical outlet.

2.Remove the Dirt Container as described in the previous section. Grasp the Filter Cup located at the bottom of the Dirt Container and twist counterclockwise to unlock and remove.

3.Grasp the Circular Filters and twist to unlock. Pull straight up to remove.

4.Separate the Outer foam and Inner pleated Circular Filters. Wash each individually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry thoroughly before putting them back together and replacing in Filter Cup.

5. The Filter Cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters.

6. The Upper Tank and Louvers may also be wiped clean with a damp cloth. Reach underneath the Upper Tank and turn the rim of the Louvers to unlock. Pull straight down to remove.

Cleaning the Pre-Motor Filter	WARNING:
	Do not operate cleaner
	with damp or wet
1. Unplug the cleaner from electrical outlet.	filters or without all
	filters in place.

2.The Pre-Motor Filter protects the motor from debris. It is located

underneath the Dirt Container and Filter Cup in the center of the	Pre-Motor
round part of the Lock ‘n Seal Lever.	Filter

3.Remove the small round Filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

Cleaning the Post-Motor Filter

Use only BISSELL Style 10 Replacement Filters in your

BISSELL PowerForce Bagless.

1.	Unplug the cleaner from electrical outlet.	Post-Motor Filter
2.	The Post-Motor Filter assists in the filtration process to return clean
	air to the room. It is located behind the door on the front of the
	cleaner. When the filter becomes dirty, open the door, remove the
			WARNING:
	filter and clean.
	The Post-Motor Filter may be hand washed in warm water. Mild		To reduce the risk of
3.			injury from moving parts,
	detergent may be used if desired. Rinse well, then air dry thoroughly		turn off vacuum cleaner
	before replacing.		and disconnect Power
			Plug from electrical outlet.

4.Replace the door by inserting the tabs on the left side and snapping the right side into place.

9