4. Reposition the drive belt on the brush roll. Place ends of brush roll in slots on sides as shown. Reposition belt cover and secure with one screw. Reposition faceplate and secure with two screws.
Replacing the HEPA Post-Motor Filter
Use only BISSELL Style 12 HEPA Filters (#3205) in your BISSELL PowerForce Turbo Bagless.
1. Unplug the cleaner from electrical outlet.
2. The HEPA Post-Motor Filter assists in the filtration process to return clean air to the room. It is located behind the door on the front of the cleaner. When the filter becomes dirty, open the door, remove the filter and replace.
Note: This filter is not washable and must be replaced.
3. Replace the door by inserting the tabs on the left side and snapping the right side into place.
Maintaining TurboBrush
The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.
1. Unplug vacuum from electrical outlet.
2. If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.
Cleaning The Inner & Outer Circular Filters continued
5. The Filter Cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters.
6. The Upper Tank and Louvers may also be wiped clean with a damp cloth. Reach underneath the Upper Tank and turn the rim of the Louvers to unlock. Pull straight down to remove.
| Cleaning Pre-Motor Filter | WARNING: |
| Unplug the cleaner from electrical outlet. | Do not operate cleaner |
1. | with damp or wet |
2. | The Pre-Motor Filter protects the motor from debris. It is | filters or without all |
filters in place. |
| located underneath the Dirt Container and Filter Cup in | |
| the center of the round part of the Lock ‘n Seal Lever. | |
3. | Remove the small round Filter and any debris on top of | |
| it. Rinse well under warm water, then air dry thoroughly | Pre-Motor |
| before replacing. |
| |
Filter
HEPA
Post-Motor
Filter
WARNING:
To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet.
3.To clean debris from the brush roll, remove the screw located by the brush roll with a Phillips head screw- driver. Lift the belt cover. Remove the brush roll from the drive belt and clean debris.
9
ug203-2829_6596_1105.indd 9 | 1/11/06 4:03:38 PM |
