Maintenance and care
Filter Maintenance or Replacement
Inlet Filter
1.Unplug the vacuum from electrical outlet.
2.Open the dust bag compartment by lifting up on the latch on the door at the front of the canister. Lift out the bag holder and bag.
3.Remove filter and clean by washing in warm water with a mild detergent if desired. Allow filter to dry completely before reinstalling. If filter is torn, replace with a new filter.
NOTE: The filter should be placed so the thicker grey foam side is visible.
4.Place bag holder and bag back into bag compartment making sure entire bag is below seal gasket.
5.Close dust bag compartment door and press down gently until it locks into place.
Final Filter
1. | Unplug the vacuum from electrical outlet. |
|
2. | Remove filter door and filter by pressing | Final Filter |
| down on tab at the back of the canister. | |
|
|
3.Remove filter and clean by washing in warm water with a mild detergent if desired. Allow filter to dry completely before reinstalling. If filter is torn, replace with a new filter.
NOTE: The filter should be placed so the thicker grey foam side is visible.
4.Reinstall filter and door by aligning notches at the bottom and pressing tab back into the canister.
8 w w w . b i s s e l l . c o m
Inlet Filter
8 0 0 . 2 3 7 . 7 6 9 1
5/22/07 5:01:19 PM
