Bissell 73A5 warranty Head screwdriver and rinsed clean. Replace after cleaning

Maintenance and care

Machine care (continued)

5.The inside of the end caps by the brush rolls can be wiped out with a clean paper towel, or, if a more thorough cleaning is desired, the end caps can be taken off using a Phillips

head screwdriver and rinsed clean. Replace after cleaning.

6.Any loose hair or debris can be pulled from the brush rolls and thrown away. For the most thorough clean before storage, follow directions on pages 18 & 19 for removal and replacement of the brush rolls and belts.

7.To clean attachments that may have been used, remove from hose and rinse in clean, running water. Dry and replace attach- ment in the tool caddy. Clean the hose by suctioning clean water from the tap. Before replacing, lift end of hose and stretch out to ensure all water is cleared from hose. Refer to page 14, illustrations 9 & 10.

8.After carpet is dry, vacuum again to remove hair and fuzz.

Small belt removal and replacement

Occasional replacement of one or both belts may become necessary. If that is needed, please follow the instructions below.

1.Turn off the machine, and unplug it from the outlet.

2.Remove both the 2-in-1 water tank and the formula tank. Set aside.

3.Unscrew the front nozzle and remove it. Set aside.

4.Turn the machine on its side. IMPORTANT: cord side down.

5.Remove the clear end cap by unscrewing the 2 black screws. Take care not to drop the screws into the unit.

6.Remove 1 silver screw from the pivot arm.

7.Remove pivot arm by gently lifting up.

8.Remove small brush belt.

9.Replace small brush belt, and reverse

steps above.

WARNING:

To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing.

1.2.

3.

4.5.

6.7.

2

1

8. 9.

18 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5