Bissell 73A5 DirtLifter PowerBrushes do not turn, Cleaner not picking up solution, Remedies

Troubleshooting

Reduce Spray or No Spray (continued)

Possible Cause

3.Tank may not be seated completely.

4.Pump may have lost prime.

DirtLifter PowerBrushes do not turn

Possible Cause

1.The belt is off or broken.

2.The unit is in the upright position.

3.Circuit breaker may have tripped.

Cleaner not picking up solution

Possible Causes

1. ReadyTools dial may be at wrong setting.

2.Tank may not be seated properly.

3. Tank may not be assembled properly.

4.Solution or 2-in-1 water tank is empty.

5.2-in-1 water tank has picked up maximum dirty water and red float door has closed.

6.Red float "door" in the tank may have closed as a result of bumping an object or moving machine back and forth too quickly.

Remedies

3.Turn power OFF ( O ). Remove and reseat tank.

4.Turn power OFF ( O ) and then back ON ( I ). Wait one minute, then depress Trigger.

Remedies

1.Turn power OFF ( O ) and unplug unit from outlet. Follow instructions on page 18.

2.Brushes only rotate when unit is reclined using the detent pedal.

3.Turn the machine OFF ( O ) and unplug from outlet. Check to see if foreign object is caught in brush roll. Remove object. Plug machine back in to reset circuit breaker.

Remedies

1. Set ReadyTools dial to either FLOOR CLEANING or TOOLS setting.

2.Pick up both the 2-in-1 water tank and formula tank and reseat them so they fit snugly on the unit.

3. Check to make sure the "lip" of the nozzle is securely hooked into the groove on bottom of Tank (see page 10).

4.Check fluid levels in heavy duty bladder and formula tank.

5.Empty 2-in-1 water tank. Refill heavy duty bladder with clean hot tap water and replace.

6.Turn the machine OFF ( O ), allowing red float door to release into the open position. Turn unit back ON ( I ) to continue cleaning. Be sure your forward and backward strokes are done at a slower pace.

20 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5