Clearing Clogs Continued
3. | Check Upper Tank and Louvers for build up or clogs. |
| Louvers | |
Check to make sure Louvers are installed correctly. To |
| |||
| unlock the Louvers, grasp the rim and turn toward the left. |
| ||
| Pull straight down to remove. If the Louvers are |
|
| |
| missing or not locked into place, check and clear the tube |
|
| |
| in the center of the Dirt Container. |
|
| Suction Inlet |
| Remove the Twist ‘n Snap Hose from the vacuum by |
| ||
4. |
|
| ||
| turning to the left. Check the Suction Inlet, Hose and Hose |
|
| |
| Wand for clogs. Remove any clogs from the hose using a |
|
| |
| long, narrow object. |
|
|
|
5. | Check the Foot Hose for clogs. If needed, remove the screw |
| Hose Wand Base | |
| attaching the Hose Wand Base to the vacuum. Straighten |
|
| |
| the Foot Hose and unclog with a long, narrow object. |
|
| |
6. | If the clog persists, follow the instructions for Checking |
|
| |
| the Rotating Floor Brush on page |
| Air Passageway | |
| Passageway for obstructions. |
|
| |
Troubleshooting | WARNING: | |||
|
| |||
|
| To reduce the risk of injury from moving | ||
|
| parts and/ or electrical shock, turn Power | ||
|
| Switch OFF and disconnect polarized plug | ||
|
| from electrical outlet before performing | ||
|
| troubleshooting checks. | ||
Vacuum cleaner won’t run |
|
|
| |
Possible Causes |
| Remedies | ||
1 | Power cord not plugged in |
| 1 | Check electrical plug |
2 | Blown fuse/tripped breaker |
| 2 | Check/Replace fuse or |
Vacuum cleaner won’t pick up dirt |
| reset breaker | ||
|
| |||
Possible Causes |
| Remedies |
1Incorrect Height Adjustment
2Hose not attached to suction opening
3Twist ‘n Snap Hose not securely attached.
4Crack or hole in Hose
5Broken or worn Drive Belt
6Rotating Floor Brush bristles worn
7Rotating Floor Brush jammed
8Clog in vacuum
129 Dirt Container full
1Adjust Powerfoot to correct height setting
2Grasp Quick Reach Handle and firmly push Hose Wand onto the suction opening
3Make sure Twist ‘n Snap Hose is snapped into locked position
4Check Hose and replace if needed
5Replace Drive Belt, see pg.
6Replace brush
7Remove brush and clean debris from brush ends
8Clear clog, see pg.
9Empty Dirt Container