Bissell 73G8 Check Rotating Floor Brush and Drive Belt Continued, Replace Drive Belt, Brush Cover

Check Rotating Floor Brush and Drive Belt Continued

3.For standard models, remove the four screws as shown with a Phillips Head Screwdriver. Lift the Brush Cover off.

For wide cleaning path models, Lift tab 1 and release the three latches in order 2-4 as marked. Lift the Brush Cover off.

4.Grasp Rotating Floor Brush at both ends and lift.

5.Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.

6.Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.

7.Check Drive Belt carefully for wear, cuts or stressed areas.

8.Check Air Passageway for obstructions. Remove debris from this area.

Replace Drive Belt

Brush Cover

Standard models only

4

Use only BISSELL Style 9 Replacement Belts (#32074) in your BISSELL CleanView II.

1.Unplug cleaner from electrical outlet.

2.With Rotating Floor Brush removed from vacuum cleaner (Steps 1-4 of Check Rotating Floor Brush and Drive Belt), grasp old Drive Belt and remove from Motor Pulley.

Discard old Drive Belt.

3.Place new Drive Belt over Motor Pulley and stretch other end over Rotating Floor Brush in the space between the bristles.

4.Place ends of Rotating Floor Brush down into slots on sides as shown.

5.Turn Rotating Floor Brush by hand several times in the direction of Motor Pulley. If properly installed, Drive Belt will center itself on Rotating Brush.

6.Reposition Brush Cover and screw or snap back into place. Check to be sure all screws or latches are secured.

Replace Lightbulb

Wide Cleaning Path models only Motor Pulley

Air Passageway

Use only BISSELL Replacement Bulbs in your BISSELL CleanView II.

1.Unplug cleaner from electrical outlet

2.Using a flat screwdriver, table knife or coin, insert into the slot on the right of the lens and gently push inner latch to the left as shown to remove the lens.

10