Replace Lightbulb Continued
3.Determine the light bulb type of your vacuum:
Standard Bulb
4.Standard Bulb – remove the bulb from the socket by grasping bulb and pulling straight out. Install the new bulb by pushing it
gently into the socket until the bulb snaps into place.
| Large Bulb - remove the bulb from the socket by pushing |
|
| bulb in gently and turning it towards brush. Install the new |
|
| bulb by pushing it gently into the socket and turning away | Standard Bulb |
| from the brush. | |
5. | Reposition lens by inserting the tab on left side and then |
|
| pushing the right side back into place. |
|
TurboBrush Maintenance
Select Models Only
The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.
1.Unplug vacuum from electrical outlet.
2.If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.
3.To clean debris from the brush roll, remove the screw located on the belt cover. Lift the belt cover. Remove the brush roll from the drive belt and clean debris.
4.Reposition the drive belt on the brush roll. Place ends of brush roll in slots on sides as shown. Reposition belt cover and secure with shorter screw. Reposition faceplate and secure with two longer screws.
Clearing Clogs
Low suction, poor pickup, or no suction may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action in the Dirt Container, check for clogs.
1.Unplug cleaner from electrical outlet.
2.Empty Dirt Container.
Large Bulb
Belt Cover 
11
