Maintenance and care
Brush roll and brush roll belt maintenance continued
Brush roll reset:
If larger debris becomes lodged in the foot of the unit and the brush roll shuts off, turn the unit off and remove the obstruction. Wait approximately 15 sec- onds for the motor to cool down before turning back on. Brush will function again after allowing time to cool down.
Brush roll belt replacement:
If the brush roll belt should break, call
Replacement instructions:
1.Turn power OFF (O). Remove foot assembly from unit and turn over to access the brush roll belt.
2.Remove three Phillips head screws to remove the belt cover.
3.Locate broken belt.
4.Replace belt.
5.Place brush roll back into foot of unit.
6.Replace the belt cover and secure with three screws.
7.Attach foot assembly on unit.
2.
3.
Disposal of batteries
WARNING:
This product contains Nickel Metal Hydride (NiMH) rechargeable batteries. According to Federal and State regulations, removal and proper disposal of NiMH bat- teries is required. For removal of the batteries in your
TM
8
If your
1. IMPORTANT: Unplug Charger.
2. Remove hand vac from unit and remove dirt cup from handle.
3. Remove (5) Phillips head screws on the handle and cover.
3.
5 screws
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |