Maintenance and care
Clearing clogs
Low suction or poor pickup may be due to a clog in dirt cup. If this occurs, follow these steps to check for and clear clog:
1.Unplug unit from electrical outlet. Ensure power is OFF.
2.Empty dirt container.
3.Check upper tank for build up or clogs.
4.Remove separator grill and check suction inlet for clog.
5.Grasp hose grip and lift to separate from suction opening. Check for clog in base or hose.
6.Release twist n’ snap hose from unit by turning hose to the left. Straighten hose and remove any clog found.
7.Check foot for clogs in air path.
Brush and wiper maintenance
Regularly check rear angle brush and front wipers on the underside of unit
to keep clean. Wipe any debris that has accumulated on the angled brush or front wipers with a damp cloth.
1. Unsnap rear angled brush by pulling up from | Wipers |
one side. Replace with a new brush by |
|
snapping into track. |
|
2 . To remove wipers, unscrew two tip screws. |
|
Slide old wiper out and insert new wiper. | Brush |
Note: Any other servicing should be performed by an authorized service representative.
8 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
6/18/08 3:44:01 PM
