Bissell 78R5, 33N8A warranty To begin cleaning, Automated cleaning

Operations

To begin cleaning

1.Place the filled clean water/solution tank onto the unit.

2.Plug your SpotBot in. The power light will illuminate, indicating your SpotBot is ready to go.

Automated cleaning

1.Place the unit directly over the spot or stain, making sure the stain is in the center of the cleaning area.

2.Select which cleaning cycle (surface stain or set-in) you would like to use. SpotBot will begin spraying, brushing and suctioning the soiled area, in a pre-programmed cycle. Both cycles have been tested and proven to deliver superior cleaning results, taking the guesswork and effort out of cleaning for you.

3.When the cleaning cycle you have selected is complete, the SpotBot will beep. The beep will continue until you hit the STOP button.

4.Pick up the unit and check the area that was cleaned.

5.If you use Oxy GEN2, it will continue to work for the next six to eight hours, cleaning your spots and stains all the way to the backing of the carpet.

Tip:

Dry vacuum the area first before spot cleaning with the SpotBot.

9

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1