Bare Floor Cleaning Technique
|
|
| Slowly move the machine nozzle with Bare Floor Tool | |
1. | ||||
| forward and back over soiled surface one time while | |||
|
|
| pressing the Trigger. Caution: Do not over wet. | |
|
| |||
|
|
| Repeat the motion without pressing the Trigger using the Bare | |
2. | ||||
| Floor Tool to squeegee and suction up the dirty water. | |||
|
|
| Repeat steps 1 and 2 backing along the exit path. | |
3. | ||||
|
|
| Allow about 30 minutes for the floor to dry completely. | |
4. |
| |||
|
|
| When the cleaning job is complete, refer to the | |
5. |
| |||
| Maintenance/Storage section on pages | |||
6. |
| To remove Bare Floor Tool gently bend long tab (right side) | ||
| outward and pull tool down away from nozzle. Rinse |
thoroughly, dry and store
Routine Maintenance
1.
2.
3.
4.
5.
6.
7.
Clean out the Flow Indicator Filter each time it is used to ensure
8. best cleaning performance. Unscrew the Flow Indicator Cap, lift out the red rotor and white filter. Rinse all 3 parts in tap water. Replace the filter with the post facing upward. Replace the rotor. Replace the Flow Indicator Cap; turn until snug, do not
|
|
| Wipe all exterior surface with a soft cloth. |
9. |
| ||
10. | Store cleaner upright in a protected, dry area. | ||
Note: ProHeat uses water and must not be stored |
where there is a danger of freezing. Freezing will damage internal components and void the warranty.
When carpet is dry, vacuum again to remove hair and fuzz
11. that the ProHeat may have loosened.
WARNING:
To reduce the risk of fire, electric shock or injury unplug from outlet before servicing.
Tip:
SmartMix Bottle may be stored with concentrate ready for your next cleaning job. Make sure dial is turned to the Water Rinse/ Carpet Protector Setting when storing.
D
Cap
Rotor
Filter
17