Carry the Tank-in-Tank, like a bucket, to the sink where you will dispose of the dirty water.
Remove Tank Lid by rotating handle forward to unlatch lid and lifting lid off tank.
Pour out dirty water.
1.
2.
3.
4.
Replace tank in machine base, seating firmly in place.
Rotate handle back down to the latched position.
Note: Both the SmartMix Bottle and the clean water tank must have liquid in them for the machine to spray. If one tank is empty the machine will not apply either cleaning solution or water only.
When It’s Time to Empty Tank-in-Tank™
Remove the Tank-in-Tank – follow steps 1 and 2 above.
Set the tank down and rotate the handle forward to
4. unlatch the lid. Lift off and set the lid aside.
Find the mouth of the Bladder and fill to the bottom of
5. the neck with clean hot tap water. *Do not boil or microwave water as it can destroy the Bladder.
Note: Fill the Bladder with clean hot tap water only.
Lift the Tank-in-Tank handle. The handle locks the lid in place.
Carry it like a bucket to fill at the sink.
Note: You may notice hair and debris deposits on
the carpet that were loosened by the brushing action (especially with newer carpets that have never been deep cleaned before). This debris should be picked up and thrown away. Debris that deposits in the Brush Belt should be cleaned between uses to keep the Belts running free.
Tank-in-Tank™
Our
Step on Handle Release to lay the machine handle
1. down out of the way.
2.
3.
Lift and Carry
3
4
Replace the Tank Lid matching the lid and tank edges.
6. Handle must be in the forward position to reinstall.
Rotate the handle to the carrying position to
Handle Release
Rotate Handle to Unlatch
7. the lid.
8.
9.
5
9
Fill bladder only with clean hot tap water
Latched 
Pour out
3 Rotate Handle to 4 dirty water 
Unlatch
8
