Operation
Oxy Gen2™ PowerTool
To use the Oxy Gen2 PowerTool:
1. | Pull out the rubber stopper in the tank. |
|
2. | Fill with Oxy Gen2™ formula. |
|
3. | Replace the rubber stopper and attach the | Rubber Stopper |
| tool to the hose grip. | |
|
|
4.Refer to page 9 “ReadyTools” steps
Maintenance and care
Machine care
For best results, a few simple steps can assure
your carpet washer is well maintained after your Lint Screen cleaning is complete.
1.Turn power switch off. Unplug the machine and wrap the power cord.
2.After emptying the dirty water tank, rinse it with running hand hot tap water, taking care to clean all around the interior.
3.If necessary, check and clean out the lint screen after each use by wiping clean any visible residue.
4.Replace the dirty water tank back into the machine.
5.Any loose hair or debris can be pulled from the PowerRoller and thrown away.
6.To clean the attachments, remove from hose and rinse in clean, running water. Dry before storing. Clean the hose by suctioning clean water from the tap. Before wrapping back on machine, lift end of hose and stretch out to ensure all water is cleared from hose.
7.Wipe the machine’s exterior with a soft cloth.
8.Machine Storage: Allow PowerRoller to dry completely before storing. Put the unit away in a closet or basement for the next use.
Store in a protected, dry area. Since this product uses water, it must not be stored where there is a danger of freezing. Freezing will damage internal components and void the warranty.
10 w w w . b i s s e l l . c o m
