Bissell 79T3 Cleaning/replacing the PowerRoller, Over-current PowerRoller motor protection

Maintenance and care

Cleaning/replacing the PowerRoller

1.Turn power switch to off and unplug the

machine.3.

2.Remove both tanks, detent the handle and turn the machine on its back.

3.Remove the 6 screws from the sole plate using a Phillips head screwdriver.

4.Turn the machine on its side so the cord side is facing up.

5.Remove the the swing arm (with dowel) and

	roller assembly.	5.
6.	Slide the PowerRoller up off the dowel and
	replace as desired.
7.	To replace, slide the PowerRoller onto the
	metal dowel and place the end with the
	taller cog down into the lower swing arm.
	Ensure the dowel is seated and that the
	belt is around the roller cog. Place the other
	swing arm in position and push the roller	6.
	down into the front cavity.

8.Re-attach the sole plate using the 6 screws.

Over-current PowerRoller motor protection

An internal over-current protector has been designed into your carpet washer to protect the 7a. PowerRoller motor from over-current. When the over-current protector activates, the PowerRoller motor will stop operating. If this happens, proceed as follows:

1.Turn the power switch off and unplug from

the electrical outlet. 7b.

2.Allow the carpet washer to sit for 15 seconds. The over-current protector automatically resets and cleaning may continue. If the PowerRoller still does not work or the over-

current protector continues to activate, your carpet washer may need servicing.

Note: The over-current protector protects the PowerRoller motor only, not the main motor. If the over-current protector activates, the carpet washer will still operate; however, the PowerRoller and spray will not work.

7c.

w w w . b i s s e l l . c o m

11