Maintenance and care
Replace drive belt
1.Unplug the vacuum from electrical outlet.
2.With the rotating floor brush removed from the vacuum cleaner (Steps
3.Place the new drive belt over the motor pulley and loop other end over the rotating floor brush in the space between the bristles.
NOTE: It is important that you use only genuine BISSELL replacement belts. Generic belts may not meet the exact specifications required to keep your vacuum operating at its peak performance. The use of unbranded belts could lead to early failure of the vacuum and could void your warranty.
4.Pull the rotating floor brush firmly into position, stretching the drive belt and place ends of the rotating floor brush down into the slots on sides. Alignment of brush ends in slots may be necessary to fully insert the brush.
5.Turn the rotating floor brush by hand sev- eral times. If properly installed, the drive belt will center itself on the rotating brush crown.
6.Insert front edge of brush cover, rotate into place, and snap 3 latches.
Replace lightbulb
1.Unplug the vacuum from electrical outlet.
2.Using a flat head screwdriver, pry the tab on the left and right side out and pull out to remove the lens.
3.Remove the bulb from the socket by grasping the bulb and pulling gently. Install the new bulb by pushing it gently into the socket until the bulb snaps into place.
4.Reposition the lens and snap it back
into place.
w w w . b i s s e l l . c o m
2.
3.
4.
8 0 0 . 2 3 7 . 7 6 9 1 | 13 |
