Maintenance and care
Cleaning the filter and screen continued
5.Separate filter assembly by grasping tabs on both sides of assembly and pull. For best results, periodically tap filter and screen against trash can to remove dirt that has collected.
6.Reconnect filter and screen by aligning rectangular tab on filter with insert on screen. Press together to ensure assembly is secure.
7.See page 5 to reattach dirt container.NOTE: The dirt container and screen may be rinsed with cold water. Ensure both are dry before reinserting. DO NOT RINSE PLEATED FILTER.
Storage/Cord wrap system
A wrap is attached to the cord for quick and easy storage.
1.To store the unit, turn hand vacuum OFF.
2.Unplug hand vacuum from electrical outlet.
3.Bundle cord, using wrap that is located on cord, to store.
Nozzle Maintenance
Keep nozzles clean and free of debris.
1.Wipe nozzles clean with damp cloth.5.5a.
6.
InsertTabTroubleshooting
Hand vacuum won’t run
Possible causes | Remedies | ||
1. | Power cord not plugged in | 1. | Check electrical plug |
2. | Thermal protector is activated | 2. | Turn OFF and unplug the unit. Empty dirt |
|
|
| container, clean filter and screen, and clear |
|
|
| any clogs. Wait 30 minutes before turning |
|
|
| the unit back on |
Hand Vacuum won’t pick up or low suction |
|
| |
Possible causes | Remedies | ||
1. | Dirt container not installed properly | 1. | Check assembly of dirt container making |
|
|
| sure it is snapped in |
2. | Dirt container is full | 2. | Empty dirt container and reattach |
3. | Filter or screen is dirty | 3. | See instructions above. Replace filter if needed |
4. | Nozzles are clogged with debris | 4. | Wipe tools clean with damp cloth |
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Please do not return this product to the store.
6 w w w . b i s s e l l . c o m
12/10/08 3:31:19 PM