Maintenance and care
Cleaning/replacing the TLR Power Roller
1.Turn power switch to OFF ( O ) and unplug
the machine. | 3. |
|
2.Remove both tanks, detent the handle and turn the machine on its back.
3.Remove the 6 screws from the sole plate using a Phillips head screwdriver, set 6 screws and sole plate aside.
4.Turn the machine on its side so the cord side is against the floor.
5. Remove the 2 screws from the belt guard | 5. |
and set aside |
|
Note: These 2 screws are the same as the 6 sole plate screws).
Remove the top of the belt guard.
6.Unhook the belt from the TLR PowerRoller
and slide the roller down through the hole
in the belt guard bottom. Slide the roller up 6. off the metal dowel (which is attached to the swing arm).
7.Clean the TLR PowerRoller by rinsing with hot water and mild soap. Allow to dry before replacing if desired.
8.To replace, slide the TLR PowerRoller on to the metal dowel with the taller cog at the
top. Push the taller cog of the roller back up 8a. through the hole in the belt guard bottom
and
9.Turn the machine on to its back and attach the second swing arm. Be sure the arm is properly in place both on the TLR PowerRoller and in the base. Push the TLR PowerRoller down so it is nested under the
nozzle.8c.
10.Re-attach the sole plate using the 6 screws.
Machine storage
Put the unit away in a closet or basement for the next use. Store cleaner in a protected, dry area. Since this product uses water, it must not be stored where there is a danger of freezing. Freezing will damage internal components and void the warranty.
w w w . b i s s e l l . c o m
6a.
8b.
9.
8 0 0 . 2 3 7 . 7 6 9 1 | 11 |
10/14/08 1:26:02 PM |
