Bissell E600, 8350 warranty Troubleshooting, Reduced Spray or No Spray, No spray through the hose

Troubleshooting

Reduced Spray OR No Spray

Possible cause

1.Clean/solution tank may be empty

WARNING:

To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing.

Remedies

1.Turn power switch OFF; Refill tank with clean hot tap water and formula

2.	Clean/solution tank may not be seated properly	2.	Turn power switch OFF; remove tank
			and reseat
3.	Pump may have lost prime	3.	Turn power switch OFF ( O ); after 1 minute
			turn ON ( I ) and depress spray trigger
			Be sure there is cleaning formula in the
			clean/solution tank, it will make the
			machine prime faster
No spray through the hose
Possible cause		Remedies
1.	Pump may not be primed	1.	Turn ReadyTools dial to FLOOR CLEANING
			and depress trigger for a few a seconds
			until you see suction coming up the nozzle
			Turn ReadyTools dial back to TOOLS
TLR PowerRoller Does Not Turn
Possible cause		Remedies
1.	The brush belt is off or broken	1.	Refer to page 11, steps 1-5 for instructions
			on how to access the belt
		2.	Look at the belt and check for breakage
			or mis-alignment on the cogs. IF there is
			no evidence, replace all parts following
			steps 8-11.
		3.	In the event your belt is broken, a
			replacement belt may be ordered at
			www.bissell.com or by calling BISSELL
			consumer services at 800-237-7691.
			Refer to the parts list on page 14. Complete
			installation instructions will come with
Machine not picking up solution			the replacement belt
Possible cause		Remedies
1.	Collection tank may not be seated properly	1.	Turn power switch OFF; reseat tank
2.	ReadyTools dial may be on TOOLS	2.	Turn ReadyTools dial to FLOOR CLEANING
3.	Float may have shut off	3.	Turn power switch OFF and empty tank if
			necessary. If tank is not full, wait
			30 seconds and turn power switch ON
4.	Collection tank may be full	4.	Turn power switch OFF and empty tank

12 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

ug120-4080_7350_908.indd 12 10/14/08 1:26:02 PM