492848-00,BDN200 NAILER 2/2/06 1:35 PM Page 10
MAINTENANCE
CLEAN AND INSPECT DAILY
Disconnect tool from air supply before cleaning and inspection. Correct all problems before placing the tool back in use.
Wipe tool clean and inspect for wear or damage. Use
Inspect trigger and safety mechanism to assure system is complete and functional: no loose or missing parts, no binding or sticking parts.
Keep all screws tight. Loose screws can cause personal injury or damage tool.
If tool is used without an
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.
TROUBLESHOOTING
Disconnect tool from air supply before performing any Service
Procedure.
SYMPTOM PROBLEMSSOLUTIONS
1.Air leak near top of tool or in trigger area.
Loose screws. | Tighten screws. |
Worn or damaged | B&D service for overhaul. |
|
2.Tool does nothing or operates sluggishly.
Inadequate air supply. | Verify adequate air supply. |
Inadequate lubrication. | Put 5 or 6 drops of oil into air inlet. |
Worn or damaged | B&D service for overhaul. |
|
3.Air leak near bottom of tool.
Loose screws. | Tighten screws. |
Worn or damaged | B&D service for overhaul. |
|
4. | Tool jams frequently. Incorrect fasteners. | Verify approved fasteners of |
|
| correct size. |
| Damaged fasteners. | Replace w/undamaged fasteners. |
| Magazine or nose | Tighten screws. |
| screws loose. |
|
| Magazine is dirty. | Clean magazine. |
| Driver is worn or damaged. B&D service for driver maintenance. | |
|
|
|
5. | Other. | Contact a Black & Decker |
|
| Service Facility. |
ACCESSORIES
Recommended accessories for use with your tool are available from your local retailer.
The use of any accessory not recommended for use with this tool could be hazardous.
10
