4.Slide raising rack (F) Fig. 7, table and table bracket onto drill press column, as shown. Make sure bottom of raising rack (F) Fig. 8, is inside the flange (J) on drill press base.
5.
STEP 1. IMPORTANT: Bottom of ring (E) MUST NOT be pushed all the way down onto top of raising rack (F). MAKE SURE top of raising rack (F) is under bottom of ring (E) and that there is enough clearance to allow rack (F) to rotate around the column. THEN TIGHTEN
SET SCREW (D) BEING CAREFUL NOT TO OVERTIGHTEN.
6.Assemble table raising and lowering handle (K) Fig. 10, to worm gear shaft (G) and tighten screw (L) against flat on shaft.
F
Fig. 7
F
J
Fig. 8
E
D
F
Fig. 9
G
L
K 
Fig. 10
8
