6
• Fill the supplied jug (10) with water to the max line, and then use jug to fill water tank (3)
.
• Close the filler cap.
NOTICe: Always empty the water tank after use.
OPeRATION
SWITChINg ON AND Off - fig. f
NOTICe:
When the steam cleaner is first turned on
the water reservoir will glow red. Once the steam cleaner
is ready to use the water reservoir will glow blue. It takes
approximately 15 seconds for the steam cleaner to heat up.
• To switch the appliance on, press the ON/OFF
button (1).
• To switch the appliance off, press the ON/OFF
button.
NOTICe:
Never leave the steam cleaner in one spot on any surface for any period of
time. Always place the steam cleaner in the upright position when stationary and make sure
the steam cleaner is turned off when not in use.
NOTICe: Always empty the water tank after use.
NOTICe: This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds.
hINTS fOR OPTIMUM USe
geNeRAL USe
CAUTION: Never use the steam cleaner without an attachment.
WARNINg: It is important to monitor the water level in the water tank. To refill the
water tank and continue to sanitize/ clean, see Filling the Water Tank section.
NOTICe:
To effectively sanitize an area, the lift and reach head with microfiber pad must be used.
NOTICe: Never leave the steam cleaner in one spot on any surface for any period of time.
Always place the steam cleaner in an upright position when stationary and make sure the steam
cleaner is turned off when not in use.
• Do not use chemical cleaners with your steam cleaner. To remove stubborn stains
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam cleaner.
hAND heLD STeAM CLeANINg
• Attach the required accessory.
• Plug hand held steam cleaner electric cord into the outlet.
• Press the ON/OFF button (1). It takes approximately 15 seconds for the hand held
steam cleaner to heat up.
• Lift the lock off (3) and pull the trigger switch (2) to activate the steam pump. After a few
seconds steam will start to come out of the accessory.
NOTICe: If the system has been run dry it may take up to 30 seconds to prime the
system on first use.
NOTICe: During use you may turn off the steam pump by releasing the trigger switch,
this convenient feature will allow you to place the steam cleaner down for a short time so
that you may move items or furniture, then continue cleaning without the need to switch
the appliance off.
• When you have finished using the hand held steam cleaner, release the trigger switch
(2) and turn it ‘OFF.’ Wait until it cools (approximately five minutes).
AfTeR USe
• Place the steam cleaner in an upright position and turn it ‘OFF’.
• Wait until the steam cleaner cools down. (approximately five minutes)
• Unplug the steam cleaner from the wall outlet.
f