5
ENGLISH
Features
This tool includes some or all of the following features:
1. On/off switch
2. Lock-on button
3. Drilling mode selector
4. Chuck
Assembly
Warning! Before assembly, make sure that the tool i
switched off and unplugged.
Fitting a drill bit or screwdriver bit Keyed chuck (fig. A)
• Open the chuck by turning the sleeve (5)
counterclockwise.
• Insert the bit shaft (6) into the chuck.
• Insert the chuck key (7) into each hole (8) in the side of
the chuck and turn clockwise until tight.
Removing and refitting the chuck (fig. B)
• Open the chuck as far as possible.
• Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
• Tighten an Allen key into the chuck and strike it with a
hammer as shown.
• Remove the Allen key.
• Remove the chuck by turning it counterclockwise.
• To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, floors or ceilings, check
for the location of wiring and pipes.
Selecting the direction of rotation
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
• To select forward rotation, push the forward/reverse
slider to the centre position.
• To select reverse rotation, push the forward/reverse
slider to the left.
Warning! Never change the direction of rotation while the
motor is running.
Selecting the drilling mode
• For drilling in masonry, set the drilling mode selector (3)
to the position.
• For drilling in other materials and for screwdriving, set
the drilling mode selector to the position.
Switching on and off
• To switch the tool on, press switch (1). For variable
speed units, the tool's speed depends on how far you
press the switch. As a general rule for variable speed
units, use low speeds for large diameter drill bits and
high speeds for smaller diameter drill bits.
• For continuous operation, press the lock-on button (2)
and release the switch. This option is available only at
full speed. This option does not work in reverse rotation.
• To switch the tool off, release the switch. To switch the
tool off when in continuous operation, press the switch
once more and release it.
Accessories
The performance of your tool depends on the accessory
used. Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.