Undo the power head release/lock knob fully.

Push down on the knob to release the latch.

Power head is free to pivot back and out of the power head tube.

Any debris should be cleared from the power head tube and blow/vac flap.

To Fit Power head (Fig. 16)

Interlock switch tab

Ensure power head release/lock knob is fully undone (ccw).

Offer up the power head and partly insert the fan into the aperture

Position the bottom recess into the mating pivot position. Rotate the power head to the fully home position. Ensure the interlock switch tab is aligned carefully.

Do up (cw) the power head release/lock knob fully NOTE: The power head has several interlock switches to prevent operation if removed from power

head tube assembly. Do not attempt to defeat these switches. Should the power head be operable, switch off and disconnect immediately. Return to your nearest service centre for repair.

WARNING: UNDER NO CIRCUMSTANCES HOSE OUT ANY PART OF THE BLOWER/VAC POWER HEAD WITH WATER OR LIQUID

Store your product in a dry place when not in use, out of the reach of children.

Do not use solvents or cleaning fluids to clean your product - use a blunt scraper to remove grass and dirt. Always disconnect from the electrical supply before cleaning.

Do not operate your product if any parts are defective; discard all defective parts and fit new parts before use.

Keep all nuts, bolts and screws tight to be sure your product is in a safe working condition.

Use only Black & Decker recommended replacement parts and accessories.

Replacement impellers are available from a Black & Decker Service Agent.

The Black & Decker policy is one of continuous improve- ment to their product and as such they

reserve the right to change product specification without prior notice.

Double Insulation

Your product is double insulated. This means that all external metal parts are electrically isolated from the power supply. This is achieved by placing an extra insula- tion barrier between the electrical and mechanical parts. Double insulation means greater electrical safety and obviates the necessity of having your product earthed.

CLEANING AND LUBRICATION

Use only mile soap and a damp cloth to clean the tool. Do not use petrol, turpentine, lacquer or paint thinner, dry cleaning fluids or similar products.

NEVER HOSE THE POWER HEAD WITH WATER.

Never let any liquid get inside the tool. Never immerse any part of the tool in liquid.

Self lubricating bearings are used in the tool and periodic relubrication is not required.

In the event that your blower/vac should ever require service, take or send it to your local Black & Decker Service Centre.

THE BLACK & DECKER AFTER SALES SERVICE

All Black & Decker products are scrupulously tested before leaving the factory. However, in the case of your power tool being defective, please take it to your nearest Black & Decker Service Center.

Printed in China

188120-00 5/01/07

22

Page 22
Image 22
Black & Decker BV2200 To Fit Power head Fig, Cleaning and Lubrication, Never Hose the Power Head with Water