Black & Decker CBM210C manual Troubleshooting, Problem, Possible Cause, Solution

F

G

8.To replace grinding assembly, set inside grinding bowl and twist slightly to the left until it falls into place. Grasp lock and release knob and turn counterclockwise to lock assembly (F). You will hear a series of clicks as the selection dial rotates, and then a distinct pop once the assembly is locked in place.

Important: Do not immerse grinding bowl, base or plug in liquid or under running water.

9.Never use harsh detergents or abrasive cleansers or scouring pads to clean any part.

10.Use the built-in cord wrap on the underside of the unit to store the cord (G).

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE	SOLUTION
Grinder stops working.	The ground coffee container	Make sure the discharge
	has disengaged.	chute is clean and free of
	There are too many beans in	coffee grinds; a buildup
	the grinding bowl.	of coffee grounds will
		cause the ground coffee
		container to slip forward.
		Unplug the appliance
		and remove some of the
		beans from the grinding
		bowl.
Coffee tastes rancid.	Grinder has buildup of coffee	Oil in the coffee beans
	grounds.	will become rancid if left
		in the grinder. Make sure
		there are no beans left in
		the grinder. Clean the
		discharge chute and the
		ground coffee container
		after each use..
Coffee tastes like nuts or spices.	Grinder has been used for	Grinder will share
	other grinding operations.	flavors; purchase another
		grinder for spices and
		nuts.
Grinder will not start.	Grinder cover is not	Grinder cover snaps into
	completely closed.	place when completely
	The ground coffee container	closed.
	is not properly placed. The	Make sure the cover
	cover is not on the ground	on the ground coffee
	coffee container. The outlet	container is in place;
	is not working.	push the ground coffee
		container securely back
		in the base so that the
		front is flush with the
		base of the base.
		Check to make sure
		outlet is working.
The ground fineness selector is	The grinding blade is not	Remove the grinding
not working.	correctly positioned.	blade and clean
		following directions in
		CARE AND CLEANING.
		Reattach grinding blade
		making sure it is fully
		integrated.

7 8