Black & Decker DCM90 manual Switching on and off, Anti-drip function, Setting the timer

Switching on and off

•To switch the appliance on, press the on/off button (3.2).

•To switch the appliance off, press the on/off button (3.2) again.

Note! Once the brewing process is complete the coffee maker will begin the Keep Warm Time. The ‘BREW’ icon ( ) will go out and the On/Off indicator light will remain on.

Pressing the ‘ON/OFF’ button (3.2), when the coffee maker is already on, will cancel the brewing process / keep warm time and will turn the coffee maker off.

Anti-drip function

The appliance is fitted with an anti-drip function, allowing you to remove the carafe at any time, even when coffee is still dripping from the filter bowl.

•Take the carafe (4) from the hotplate (5) and pour the desired amount of coffee.

•Replace the carafe (4) on the hotplate (5) and allow the remainder of the coffee to drip into the carafe (4).

Setting the timer

Warning! Make sure that you have put water in your coffee maker before setting the timer..

•Prepare your coffee by following the instructions for ‘Adding coffe’ and ‘Adding water’.

•Press and hold the ‘PROG/AUTO’ button (3.1) for 3 seconds. The ‘PROG/AUTO’ indicator light will start to flash indicating you are in programming mode and the display will show the ‘Automatic Coffee Making Icon’ ( )

ENGLISH

Note! The last programmed time will be displayed.

•Press the ‘Hour’ (3.3) and ‘Min’ (3.5) buttons to select the time you want your coffee maker to automatically start. (AM is indicated in the upper left hand corner of the clock display and PM in the lower left hand corner).

•Press the ‘PROG/AUTO’ button (3.1) four times to set the timer and to exit programming mode. The pre-set time will be displayed briefly. The PROG/AUTO’ indicator light will illuminate and the display will show the ‘Automatic Coffee Making Icon’ ( ). The coffee maker is now in automatic timer mode.

•When the programmed time is reached your coffee maker will start to brew the coffee.

Note! To turn the timer OFF or ON press the ‘PROG/AUTO’ button (3.1).

Note! The coffee maker will continue to keep warm until the programmed ‘Keep Warm Time’ time has elasped, then the coffee maker will switch itself off.

Setting the keep warm time

•Press and hold the ‘PROG/AUTO’ button (3.1) for 3 seconds. The ‘PROG/AUTO’ indicator light will start to flash indicating you are in programming mode. The display will show the current time and automatic coffee making icon ( )

•Press the ‘PROG/AUTO’ button (3.1) again.

•Repeatedly press the ‘HOUR’ button (3.3) until the desired ‘Keep Warm Time’ has been selected. (1 - 5 hours - default = 2 hours).

•Press the ‘PROG/AUTO’ button (3.1) twice to exit the programming mode.

•The display will then revert back to the clock.

7