Black & Decker DV60XXY manual Cleaning and maintenance, Protecting the environment

While charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely. The charging indicator (5) will be lit as long as the appliance is connected to the plugged-in charger.

Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C.

Adjusting the dust collector (fig. D) Extend the dust collector (2) by pulling the dust collector extension

(1)until it locks into position. Retract the dust collector extension

(1)by pressing the area (12) marked with an arrow and pushing the dust collector extension (1) back into the dust collector (2).

Switching on and off (fig. E & F)

To switch the appliance on, slide the on/off switch (4) forward.

To switch the appliance off, slide the on/off switch (4) back.

DV1205 & DV9605 - Optimising the suction force (fig. G)

In order to keep the suction force optimised, the filters must be cleared regularly during use.

Slide the filter cleaning button (6) up and down a few times to shake out dust clogging the filters (10 & 11).

Wash the filters in warm, soapy water (fig. K). The dust collector (2) can also be washed if necessary.

Warning! Do not immerse the appliance in water.

Make sure that the dust collector (2) and the filters (10 & 11) are dry. Refit the filters (10 & 11) on to the appliance, twisting them counter- clockwise until they lock into place. Refit the dust collector (2) onto the appliance. Make sure that the dust collector clicks into place.

Warning! Never use the appliance without the filters. Optimum dust collection will only be achieved with clean filters.

Replacing the filters

The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from your Black & Decker dealer (cat. no. VF70, VF80 for HEPA filters):

Remove the old filters as described above.

Fit the new filters as described above.

Storing the accessories (fig. L & M) Press the accessories into the corresponding holders until they click into place.

Cleaning and maintenance

Warning! Regularly clean the filters (10 & 11).

Cleaning the dust collector and filters (fig. H - K)

The filters are re-usable and should be cleaned regularly.

Press the release button (3) and remove the dust collector (2). Empty the dust collector (2) (fig. I). Remove the filters (10 & 11) by twisting them clockwise (fig. J). Separate the filters (10 & 11) Brush any loose dust from the filters (10 & 11).

Protecting the environment

Separate collection. This

product must not be disposed

of with normal household waste.

Should you find one day that your appliance needs replacement, or if it is of no further use to you, think of the protection of the environment. Black & Decker repair agents will accept old Black

&Decker tools and ensure that they are disposed of in an environmentally safe way.

7