Middleby Marshall PS200-R68 Section Maintenance, Figure, Do not adjust belt if HOT

Figure 4-29.

Conveyor

Rear Stop

Conveyor

End Stop

Middleby

Marshall

SECTION 4

MAINTENANCE

e. Checking conveyor belt tension.

NOTE: Oven conveyor belt must be cool when adjusting belt.

Do not adjust belt if HOT.

AA.With the conveyor assembly in the oven, stand at one end of conveyor and check tension by lifting the conveyor belt at the center of the oven chamber opening. The belt should not lift higher than 3 to 4 inches (76mm to 102mm).

BB.Adjust conveyor chain tension screws (located on left end of oven) for the 3" to 4" deflection shown in the photo.

CC.If conveyor belt is still not under proper tension recheck your adjustment of the conveyor tension screws. If correct adjustment is not possible call your service agency.

Middleby Marshall

Removable

Crumb

Pans

Removable

Crumb

Pans

Lower End	Notch In Lower
Plug
	End Plug

Figure 4-30.

f. Reinstall conveyor end stop and rear stop.

7.Reassemble upper end plugs to both ends of oven. Refer to Figure 4-30. Notice that the upper end plug is not notched. Secure the end plugs to oven using the wing nuts.

49