Middleby Marshall PS200-R68 Maintenance, Figure, Using 2 people install the conveyor

SECTION 4 MAINTENANCE

Upper End

Plug

Removable

Crumb Pans

Lower End Plug	Notch in Lower
	End Plug

3.Reassemble lower end plugs to both ends of oven. Refer to Figure 4-24. Notice that the lower end plugs have a notch in them. Position the lower end plugs against the oven and then up into place. Use the wing nuts to secure the end plugs to the oven.

Gear

Chain Cover

Figure 4-24.

4. Reassemble top fingers and blank plates into oven. Refer to Figure 4-16, 4-22 & 4-23.

5. Spray Kote on any areas that may have been wiped off.

6. Using 2 people install the conveyor.

a. Lift the conveyor and start it into the drive end of the oven. The drive end of the oven is the end with the machinery compartment at- tached. Slide the conveyor along the side guides until the crumb tray slide falls into place at the opposite end.

Figure 4-25.

47