Middleby Marshall PS200-R68 installation manual attempting to disassemble, clean or service ovens

Conveyor

End Stop

Conveyor Rear Stop

SECTION 4

MAINTENANCE

C. Crumb Pans

Remove the crumb pan(s) at both ends of the oven. Crumb pans are removed by sliding out as shown in Figure 4-2. Wash the crumb pans in the pot sink.

Figure 4-2.

CAUTION

Possibility of injury from rotating parts and electrical shock exist in this oven.

Turn off and lockout or tagout electrical supply to oven(s) before

attempting to disassemble, clean

or service oven(s).

Never disassemble or clean the oven with the fan switch or any other part of the oven turned "on".

II.MAINTENANCE WEEKLY - Oven Disassembly and Cleaning

Use the following instructions to clean the oven interior once a week. To clean the interior 2 people are required to disassemble the oven. Disassemble the oven the night before and soak the removed parts overnight. Then clean the oven in the early morning before

production and line setup. Approxi- mately 2 hours is required.

Middleby Marshall

Middleby Marshall

Removable

Crumb

Pans

Removable

Crumb

When cleaning your Series PS200-R68 oven note the following:

PRECAUTIONS-

1.Do not use excessive water or satu- ration of oven insulation will occur.

2.Do not get water in the fan area located in the bake chamber.

A. Removing conveyor from oven for cleaning

1. Remove crumb pans, conveyor end

stops and conveyor rear stops shown

in Figure 4-2.

2. Remove upper end plugs from each

end of oven. The two wing screws in

each end plug are loosened and then

Notch In Lower

End Plug

Figure 4-3.

Pans

the end plugs are removed and set

aside. The wing screws should be held

in the end plugs by locking washers. If

your wing screws drop out of the end

plugs order new screws from your local

service agency.

36