Middleby Marshall PS200-R68 Section Installation, I.Unloading, Oven And Combustible Construction

SECTION 2

INSTALLATION

SECTION 2

INSTALLATION

NOTE: For U.S. installations the installation must conform with local codes or in absence of local codes, with

ANSI Z223.1-latest edition and electrical code ANSI/NFPA No. 70-latest edition.

NOTE: For Canadian Installations - The installation should be done in accordance with the CAN 1-B149.1 or .2 installation code and/or local code and the Canadian electrical code, Part 1, CGA C22.1 for the electrical features.

I.UNLOADING

Your Middleby Marshall Series PS200-R68 Oven(s) is shipped partially assembled and it will arrive in a carton.

Carton size for all Series 200-R68 Ovens is: 84"(2134mm) Long x

58" (1473mm) Wide x 44" (1118mm) High.

A Pre-installation Procedures Manual (MM P/N 88910-0009) is attached to the exterior wall of the carton. This manual contains detailed instructions on unpacking and moving the oven(s) into your facility. When your common carrier or truck line notifies you of delivery, you must have a forklift at the facility to unload the carton(s).

Instructions for stacking the ovens are contained in a separate manual issued to Middleby Marshall Certified Installers.

If you have a door wider than the carton simply move the carton into your facility and set up an appointment with your Certified Middleby Marshall Installer.

If your door is narrower than the carton, then the oven will have to be uncrated. Follow directions shown in the Pre-Installation Procedures Manual.

Each crate must be examined before signing the Bill of Lading. Report any visible damage caused by the trucker in transit, and check for the proper number of crates. If apparent damage is found, arrangements should be made to file a claim against the carrier. Interstate Commerce Regulations require that the claim must be initiated by the consignee within 10 days from the date it is received.

NOTE

There Must Be Adequate Clearance Between

Oven And Combustible Construction.

Clearance Must Also Be Provided For

Servicing And For Operation.

CAUTION: It is required that the oven be placed under a ventila- tion hood for adequate air supply and ventilation.

CAUTION: A minimum clearance of 0" from non-drive end of oven to wall, 18" from drive end of oven to wall and 6" from rear wall to air openings at rear of unit must be maintained. For servicing and cleaning a minimum of 18" clearance from all walls and combustible materials is recommended.

CAUTION: Do not obstruct the flow of combustion and ventila- tion air to and from your oven. Do not obstruct the ventilation holes in the control panel, as these provide the combustion air for the burner.

9