English
•Do not store in locations where the temperature may exceed 40°C.
•Charge only at ambient temperatures between 10°C and 40°C.
•Do not incinerate the battery.
•When disposing of batteries, follow the instructions given in the section "Protecting the environment".
•Have defective cords replaced immediately.
•Do not expose the charging base to water.
•Do not open the charging base.
•Do not probe the charger.
Electrical safety
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug.
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the ambient temperature becomes too high. As soon as the ambient temperature has cooled down, the charger will resume operating.
+40∫C Charge only at ambient
+10∫C temperatures between 10°C and
40°C.
Charging.
Features
1.Pivot lock trigger
2.Dust container door
3.Release latch (for dust container door)
4.Charging base
5.Charging indicator
6.Pivoting arm
7.Beater bar/vac head
8.Maintenance access panel
9.Beater bar/vac On/Off switch
Installation
Attaching the handle to the appliance
(fig. A)
•Align the
•Remove the phillips head screw from the plastic bag.
•Insert the screw (13) into the hole.
•Tighten the screw (13) using a phillips screwdriver.
Charging base (fig. B)
Place the charging base (4) on the floor, convenient to an electrical outlet. The Pivot Plus® slim vac is stored and charged in the base whenever it is not in use.
Warning! Falling/tripping hazard. Do not place the charging base on any elevated surface. The appliance is designed to be placed into and removed from the charging base when it is sitting on the floor convenient to an electrical outlet.
