tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and cleanProperly. maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
6. Electrical safety
Your tool is double insulated; therefore no earth wire is required. Always check that the main voltage corresponds to the voltage on the rating plate. Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized
Black & Decker Service Center or an equally qualified person in order to avoid damage or injury. If the power cord is replaced by an equally qualified person, but not authorized by Black & Decker, the warranty will not be valid.
7.Labels on tool
The label on your tool may include the following symbols:
| Read Instructions Manual |
|
|
|
| ........ | Alternating Current |
| Use Eye Protection |
|
|
|
| ........ | Direct Current |
| n0 | ||||||
| |||||||
| Use Ear Protection |
|
|
| ........ | Class II Construction | |
V | Volts |
|
|
| ........ | Earthing Terminal | |
|
|
|
|
| |||
|
|
|
|
| |||
.../min | Safety Alert Symbol | ||||||
A | Amperes | Revolutions or | |||||
Hz | Hertz |
|
|
|
|
| Reciprocation |
W | Watts |
|
|
|
|
| per minute |
min | minutes |
|
|
|
|
|
|
ADDITIONAL SAFETY WARNINGS
To Reduce Risk of Injury:
Before any use, be sure everyone using this tool reads and understands all safety instructions and other information contained in this manual.
ENGLISH
Caution! Wear appropriate personal hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
SAFETY SPECTACLES OR GOGGLES — Wear at all times when trimming.
GUARD — Do not use trimmer without guard attached.
NYLON LINE — Keep face, hands and feet clear of rotating nylon line at all times. Do not extend beyond length specified in this manual. Wear long pants to protect your legs.
KEEP ALL
AVOID ACCIDENTAL STARTING — don’t carry plugged in tool with finger on trigger.
DO NOT FORCE THE TOOL — at a rate faster than the rate at which it is able to cut effectively.
USE THE RIGHT TOOL — Do not use this tool for any job except that for which it is intended.
DON’T OVERREACH — Keep proper footing and balance at all times.
WARNING — To prevent electric shock hazard, use only with an extension cord suitable for outdoor use. Always connect extension cords to a fused line or one protected by a circuit breaker.
DON’T ABUSE CORD — Don’t yank cord from receptacle. Keep cord from heat, oil and sharp edges.
EXTENSION CORDS — to prevent disconnection of extension cord during operation, use extension cord retainer as described in this manual.
DAMAGE TO UNIT — If you strike or become entangled with a foreign object, stop trimmer immediately, unplug, check for damage and have any damage repaired before further operation is attempted. Do not operate with a broken hub or spool.
DAMAGE TO CORD — Keep power cord away from rotating line. If you damage the extension cord, unplug it at the electrical outlet before moving the trimmer or examining the damage. If there is damage to the extension cord, replace cord before further use.
If the cord gets damaged or cut, disconnect immediately from plug.
DISCONNECT TOOL — When not in use, when replacing |
line, or prior to cleaning hub. |
DRESS PROPERLY — Don’t operate the tool when |
barefoot or wearing open sandals. Always wear substantial |
footwear. Use of rubber gloves and substantial rubber soled |
footwear is recommended when working outdoors. |
AVOID DANGEROUS ENVIRONMENTAL CONDITIONS |
— Do not use electric tools in damp or wet locations. Follow |
Saveand intheseinstructinginstructionsothers.and review frequently prior to use
13
all instructions in this instruction manual for proper operation |