Black & Decker GLC120 manual Fitting the guard fig. B, Fitting the secondary handle fig. D

E N G L I S H

CARTON CONTENTS

The carton contains:

1Cordless grass trimmer

1Charger

1Guard with mounting screw

1Wall mount

2Mounting screws

2 Wall plugs

1Instruction manual

◆Carefully unpack all parts.

OVERVIEW (fig. A)

1.On/off switch

2.Lock-off button

3.Battery housing

4.Secondary handle

5.Handle knob

6.Head release knob

7.Motor housing

8.Guard

9.Line trimming blade

10.Edge guide

11.Spool

12.Cutting line

13.Charger

14.Wall mount

ASSEMBLY

Avoid accidentally switching the tool on during assembly.

Fitting the guard (fig. B)

◆Remove the screw (15) from the guard (8).

◆Place the guard onto the tool as shown.

◆Firmly press the guard until it snaps into place.

◆Secure the guard with the screw (15).

Never use the tool unless the guard is properly fitted.

Mounting the wall mount to the wall (fig. C) The wall mount (14) is used to provide a convenient storage and charging point for the tool.

◆Find a suitable indoor location for the wall mount. If you also want to charge the battery on the wall mount, this location must be dry and well ventilated.

◆Position the wall mount as shown and mark the location of the two mounting holes (16) on the wall. Make sure that there is sufficient space to hang the tool on the wall mount.

◆Drill a hole (ø 6 mm, approx. 35 mm deep) at each of the marked locations.

◆Insert the plugs (17) provided into the holes.

◆If you do not want to use the wall mount location for charging the battery, remove the charging insert from the wall mount.

◆If you want to use the wall mount location for charging the battery:

-Guide the cable (19) through one of the slots (20) as shown.

-Plug the charger (13) into a mains outlet.

◆Mount the wall mount to the wall using the screws (18) provided.

Fitting the secondary handle (fig. D)

◆Unscrew the handle knob (5).

◆Set the handle onto the tool as shown.

◆Fasten the handle using the handle knob and screw as shown.

USE

Let the tool work at its own pace.

Do not overload.

Charging the battery (fig. G & H)

The battery needs to be charged before first use and whenever it fails to produce sufficient power on jobs that were easily done before. To maximise the lifetime of the battery, it is recommended to keep the battery connected to the charger whenever the tool is not in use. When the battery is full, the power consumption of the charger is negligible.

Do not charge the battery at ambient temperatures below 5 °C or above 40 °C. Recommended charging temperature: approx. 24 °C.

12