Storage
When the tool will not be used for several months, ideally leave the battery connected to the charger. Otherwise proceed as follows:
◆Fully charge the battery.
◆Store the tool in a secure and dry location. The storage temperature must always remain in the range of +5 °C to +40 °C.
◆Before using the tool after prolonged storage, fully charge the battery again.
TROUBLESHOOTING
If your tool seems not to operate properly, follow the instructions below. If this does not solve the problem, please contact your local Black & Decker repair agent.
Tool runs slowly
◆Check that the spool housing can rotate freely. Carefully clean it if necessary.
◆Check that the cutting line does not protrude more than
◆Connect the battery to the charger and plug the charger in. Wait until the green indicator light lights up to ensure that the battery is fully charged.
Automatic line feed does not work
◆Keep the tabs depressed and remove the spool cover from the spool.
◆Lift the spool approx. 6 mm and pull the cutting line until it protrudes
◆Push the spool back into place and rotate it slightly until it is seated.
◆Align the tabs on the spool cover with the holes in the housing.
◆Push the cover onto the housing until it snaps securely into place.
◆If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade.
E N G L I S H
If the automatic line feed still does not work or the spool is jammed, try the following suggestions:
◆Carefully clean the spool cover and housing.
◆Remove the spool and check if the lever (32) can move freely (fig. E).
◆Remove the spool and unwind the cutting line, then wind it on neatly again as described above. Replace the spool as instructed.
◆Push the cover onto the housing until it snaps securely into place.
PROTECTING THE ENVIRONMENT
Tools
Should you find one day that your tool needs replacement, or if it is of no further use to you, think of the protection of the environment. Black & Decker repair agents will accept old Black & Decker tools and ensure that they are disposed of in an environmentally safe way.
Battery (fig. O & P)
If you want to dispose of the tool yourself, the battery must be removed as described below and disposed of in accordance with
Pb | local regulations. |
|
◆The battery liquid contains diluted sulphuric acid which can be harmful. Sulphuric acid on the skin will cause burns and if in contact with the eyes may cause loss of sight. In case of skin contact, flush immediately with water. Neutralize with a mild alkaline solution such as milk or bicarbonate of soda. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Seek medical attention.
◆Do not
◆Be aware that the battery is heavy.
◆If possible, operate the tool to run the battery down completely.
◆Remove the secondary handle from the tool.
15
