The strap should be kept on the battery at all times.
•
• Always store your mower in a dry and cool location.
• Keep the mower and battery away from water, heat sources (such as radiators, heaters, stoves etc.), flames or chemicals.
Battery strap
• Locate the battery and its carrying strap.
• Fold the sides of the strap up and put the battery in place.
• Click the straps together ensuring you locate every hole.
Storage duration is less than 6 months.
•
Battery information
• The battery in your cordless lawnmower is a 12 volt sealed lead acid system. The battery employs an absorbed electrolyte and, can therefore, be stored in any position without fear of leakage.
• The battery has been charged at the factory, however, it will be necessary to recharge the battery to ensure full charge before initial use.
• For optimal performance the battery should be recharged after each use.
• For winter storage ensure:
• The mower is fully charged before storing.
• The temperature of the storage location is below 25˚C.
Push the support frame firmly into place.
Assemble the two side clips to the support frame, then assemble the bottom clip.
C2 •
C3 •
• Secure the grassbag by inserting the bag rim into the channel and pushing down firmly until the clip feature locks onto the bag rim (inset).
Before starting to assemble the grassbag, check that the parts are similar to those shown in Fig. C1.
C1 •
Grassbag assembly (Fig. C)
Note: Ensure the battery is disconnected.
Read the safety instructions at the beginning of this manual before using this accessory.
When both handles are assembled, fit one cable clip (18) onto the upper handle and one onto the lower handle. Clip the cable into these ensuring the grassbox can be removed and positioned freely.
B3 •
Unpacking and assembly
Your mower carton contains:
•The mower and handle assembly.
•One hardware bag containing:
•Two safety keys (24).
•Instruction literature.
•Blade nut spanner (25).
•Charger (26).
•Battery strap (27).
•One grassbag assembly (19) - see below for assembly instructions.
Handle assembly (Fig. A & B)
A | Remove the contents of the carton and |
familiarise yourself with the individual parts of |
| the mower. |
| The main parts of the mower shown in Fig. A |
| are as follows: |
| • | Machine body (1): |
| | • | Cutter deck (2) |
| | • | Motor cover (3) |
| | • | Battery cover (4) |
| | • | Grass flap (5) |
| | • | Wheel assembly (6) |
| | • | Pivot pin (7) |
| | • | Grill (8) |
| • | Handle (9): |
| | • | Upper handle (10) |
| | • | Lower handle (11) |
| | • | Handle knob (12) |
| | • | Switch lever (15) |
| | • | Switch box (16) |
| | • | Electric cable (17) |
| | • | Retaining clips (18) |
The lower handle (11) comes ready assembled to the mower body.
All that is required is to unfold the handle by lifting it until the handle ends snap into their locations on the sides of the mower. Once this is complete the knobs (12) can be tightened.
B2 • The upper handle (10) is assembled by fitting the bolts (13) through the holes in the lower handle, aligning the upper handle over these and securing with a washer (14) and then the knob (12).
•Tighten each one with hand pressure only. Do not use a spanner.
4
