Black & Decker GS2400 manual Extension cables, Mains supply, Operation, Maintenance and storage

uYour appliance is designed for use on AC (mains) electrical supplies only. Do not attempt to use it on any other supply.

Extension cables

uWhen using the appliance outdoors, only use extension cables intended for outdoor use.

uUp to 25 m 1.5 mm 3-core extension cable can be used without loss of power.

Mains supply

The product meets the technical requirements of

EN 61000-3-11. This equipment is subject to conditional connection and the user, in consultation with the supply authority if necessary, shall be instructed to connect it only to a supply of impedance 0.087 + j0.087 Ohm or less.

Operation

uBefore starting the appliance, look into the feeding chamber to make certain that it is empty.

uKeep your face and body away from the feed intake opening, long branches may lash out when being pulled in by the cutting gear. Do not allow hands or any other part of the body or clothing inside the feeding chamber, discharge chute, or near any moving part.

uKeep proper balance and footing at all times. Do not overreach. Never stand at a higher level than the base of the appliance when feeding material into it.

uAlways stand clear of the discharge zone when operating this appliance.

uWhen feeding material into the appliance be extremely careful that pieces of metal, rocks, bottles, cans or other foreign objects are not included.

uIf the cutting mechanism strikes any foreign objects or if the appliance starts making any unusual noise or vibration, turn the appliance off, remove the plug from the mains and allow the appliance to stop.

-Inspect the appliance for damage.

-Check for and tighten any loose parts.

-Have any damaged parts replaced or repaired with original parts by an authorised repair agent.

uDo not allow processed material to build up in the discharge zone; this may prevent proper discharge and can result in kickback of material through the feed intake opening.

uIf the appliance becomes clogged, turn the appliance off, remove the plug from the mains and allow the appliance to stop before clearing debris.

uKeep all guards and deflectors in place and in good working condition.

uDo not transport or tilt the appliance whilst in operation.

uDo not leave the appliance unattended. Whenever you leave the work area, turn the appliance off, remove the

plug from the mains and allow the appliance to stop. Children must be supervised to ensure they do not play with the appliance.

uDo not tilt the appliance while the power source is running.

Maintenance and storage

uWhen the appliance is stopped for servicing, inspection, or storage, or to change an accessory, turn the appliance off and remove the plug from the mains. Make sure that all moving parts have come to a complete stop before making any inspections, adjustments, etc.

uStore the appliance in a dry and locked location. Children should not have access to stored appliances.

The following warning symbols are found on the appliance:

t Read the manual prior to operation.

Danger - rotating blades. Keep hands and feet out of R openings.

Do not use the tool in wet conditions of expose it to F rain.

Always wear eye protection.

Before performing any maintenance, switch off and unplug the appliance.

Keep bystanders away.

Always wear safety glasses, ear protection and a G respirator.

Wear gloves when operating this tool.

Electrical safety

uIf the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.

7