Features

1.On/off switch 2.Carrying strap 3.Wand 4.Wand handle 5.Tank cap 6.Suction tube 7.Nozzle 8.Power head 9.Tank

Assembly and adjustment

Warning! Make sure that the sprayer is switched off.

Attaching the carrying strap (fig. A)

uAttach the clips (10) of the strap (2) to the openings (11) on the power head.

Assembling the spray wand (fig. B)

uInsert the wand (3) into the wand handle (4) until it locks into place.

uTighten the cap (12) onto the handle.

Fitting the nozzle (fig. C)

uScrew the nozzle (7) onto the handle tip (13).

Adjusting the cone type nozzle

uTurn the nozzle (7) clockwise for narrow misting applications.

uTurn the nozzle (7) counterclockwise for wide misting applications.

Removing and replacing the power head (fig. D & E)

uUnscrew the tank cap (5) (fig. D1).

uRemove the suction tube (6) from the tank (9).

uRelease the latch (14) by pressing it downward (fig. E).

uRaise the back of the power head (8) and move it forward (fig. D2).

uPull off the power head (8).

uTo attach the power head (8), align the slots (15) in the power head with the tabs (16) on top of the tank (9) (fig. D2 & D3).

uMove the power head (8) backward until it locks into place.

uFit the bracket (17) over the latch attachment (18) (fig. E).

uPush the latch (14) upward until it locks into place.

uPlace the suction tube (6) in the tank.

uReplace the tank cap (5) and tighten it.

Use

Warning!

uUse safety equipment.

uOnly spray in well-ventilated areas.

uOnly use recommended chemicals as described in the safety instructions.

Charging the battery (fig. F)

The battery needs to be charged before first use and whenever it fails to produce sufficient power on jobs that were easily done before. When charging the battery for the first time, or after prolonged storage, it will only accept an 80% charge. After several charge and discharge cycles, the battery will attain full capacity. The battery may become warm while charging; this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient temperatures below 10 °C or above 40 °C. Recommended charging temperature: approx. 24 °C.

uPull out the socket cover (19).

uInsert the charger plug (20) into the charger connector (21) at the rear of the appliance.

uPlug in the charger.

uSwitch on at the mains.

uLeave the appliance connected to the charger for 14-18 hours. Whilst charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely.

uBefore using the appliance, unplug the charger and disconnect the appliance from the charger.

uReplace the socket cover (19).

Warning! The appliance does not operate while it is connected to the charger.

Filling the tank (fig. D1)

uUnscrew the tank cap (5).

uRemove the suction tube (6) from the tank (9).

uFill the tank with an appropriate liquid.

Warning! Only use appropriate chemicals as described in the safety instructions.

Switching on and off

uTo switch on, press the button (1).

uTo switch off, release the button (1).

Warning!

uAlways spray downwind, away from people and animals.

uOnly use nozzles specified by the manufacturer.

uIf the nozzle clogs, switch off the appliance immediately.

9