Black & Decker HX325 Oscillation, Safety Switch, Safety Fuse, How to take care of your Fan Heater

Oscillation:

•This appliance has an oscillation mode. This allows the appliance to partially rotate in 2 directions to warm or cool a room over a wider area.

•To operate the oscillation mode, press the oscillation switch (4) to the on position. The upper part of the appliance will rotate to the left or right, changing direction after a short time then begin to move in the original direction again. This cycle will continue as long as the oscillation button is in the on position and the appliance is connected to the electrical supply.

•To stop the oscillation, press the oscillation switch (4) to the off position (0).

•Oscillation can be used in both Heater and Fan modes.

Safety Switch

This appliance incorporates a safety switch (6) on the bottom of the unit. If the appliance is knocked over or lifted up, the switch operates and the unit will turn off. Placing the unit back in an upright position or returning it to the floor after carrying will re-set the switch and the product will continue to operate as before.

Safety Fuse

In case of overheating, a cut-out will operate and the appliance will stop working. If the appliance stops operating, turn the heating selector (3) and oscillation switch (4) to 0, unplug the appliance and allow it to cool for at least 10 minutes before attempting to use it again.

In extreme conditions, a back-up cut-out will operate. This will not re-set & the appliance will need to be repaired by a qualified person.

How to take care of your Fan Heater

Cleaning your Fan Heater:

•Switch off the appliance before cleaning, changing accessories or approaching parts which move in use.

•Do not immerse the appliance, cord set or plug in liquids

•Wipe the appliance with a damp cloth & dry thoroughly before using.

•The air inlet grill (7) can be removed for cleaning:

•To remove the grill, push the 2 tabs (9) down & pull the cover off.

•Remove the filter (10) from the grill & clean with a soft brush.

•The rest of the air inlet grill may be cleaned with a damp cloth. Dry the cover thoroughly before re-fitting.

•The exposed vents in the heater must only be cleaned with a soft brush.

•To replace the grill, place the bottom of the grill in the recess in the heater, then push the top of the grill into position, making sure the tabs (9) lock in place.

Additional Safety Warnings:

•Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.

•Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.

•Combustible materials such as furniture, pillows, bedding, papers, clothes and curtains must be kept at least 1m from the front of the appliance.

•Do not allow anything to block the vents at the rear of the appliance. A gap of at least 15cm is advised.

•Always use and store in a dry area.

•Do not use in areas where gas, paint or other flammable goods may be present.

-5-