DUAL RANGE GEARING (FIGURE G)

G

 

The dual range feature of your drill allows you

 

to shift gears for greater versatility. To select

 

5

low speed, high torque setting (position 1), turn

 

tool off and permit to stop. Slide gear shifter

 

 

button (5) away from the chuck. To select the

 

 

high speed, low torque setting (position 2), turn

 

 

tool off and permit to stop. Slide gear shifter

 

 

button towards the chuck.

 

 

NOTE: Do not change gears when tool is

 

 

running. If you are having trouble changing

 

 

gears, make sure that the dual range gear

 

 

button is either completely pushed forward or

 

 

completely pushed back.

 

 

SCREW DRIVING

 

 

For driving fasteners, the reversing button should be pushed to the left. Use reverse

(button pushed to the right) for removing fasteners. When moving from forward to reverse,

or vice versa, always release the trigger switch first.

 

ON BOARD BIT STORAGE (FIGURE H)

 

H

A bit storage slot (10) is built-in to the area just above the

 

battery pack.

 

 

10

(FIGURE I)

WhenLED Workdrill is activatedLight by pulling the trigger switch (1), the integrated LED work light (6) will automatically illuminate the work area. Do not use LED work light as flashlight.

I

6

DRILLING

• Use sharp drill bits only.

• Support and secure work properly, as instructed in the Safety Instructions.

• Use appropriate and required safety equipment, as instructed in the Safety Instructions.

• Secure and maintain work area, as instructed in the Safety Instructions.

• Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit from slipping out of it.

• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting

• but not so much as to stall the motor or deflect the bit.

• DOHoldNOTtheCLICKdrill firmlyTHEwithTRIGGERtwo handsOF AtoSTALLEDcontrol DRILLits twistingOFF ANDactionON. IN AN ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN RESULT.

• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part of the hole.

• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce

• jamming.

Make sure switch turns drill on and off.

DRILLING IN WOOD

Holes in wood can be made with the same twist drill bits used for metal or with spade bits. These bits should be sharp and should be pulled out frequently when drilling to clear chips from the flutes.

10

Page 10
Image 10
Black & Decker LDX220SBR Dual Range Gearing Figure G, Screw Driving, On Board BIT Storage Figure H, Drilling