important safety instructions

important safety instructions

for battery chargers

SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.

Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack.

Manual background WARNING: Shock hazard. Do not allow any liquid to get inside charger.

Manual background CAUTION: Burn hazard. To reduce the risk of injury, charge only designated Black & Decker batteries. Other types of

batteries may burst causing personal injury and damage.

Manual background CAUTION: Under certain conditions, with the charger plugged in to the power supply, the charger can be shorted by

foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

Manual background WARNING: The charger supplied with this product is intended to be plugged in such that it is correctly orientated

in a vertical or floor mount position.

DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

These chargers are not intended for any uses other than charging designated Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

Do not expose charger to rain or snow.

Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.

Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

Recommended Minimum Wire Size for Extension Cords

 

 

 

Volts

Minimum Gauge for Cord Sets

 

Total Length of Cord in Feet

120V

 

0-25

26-50

51-100 101-150

240V

 

0-50

51-100 101-200

201-300

Ampere Rating

American Wire Gauge

More Not more

Than Than

 

 

 

 

0

-

6

18

16

16

14

6

-

10

18

16

14

12

10

-

12

16

16

14

12

12

-

16

14

12

Not Recommended

Do not

place any object on top of charger or place the

charger

 

on a soft surface that might block the ventilation slots and

 

result in excessive internal heat. Place the charger in a position

 

away from any heat source. The charger is ventilated through

slots in the top and the bottom of the housing.

Do not mount charger on wall or permanently affix charger to

 

any surface. The charger is intended to use on a flat, stable surface

(i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have

them replaced immediately.

Do not operate charger if it has received a sharp blow, been

 

dropped, or otherwise damaged in any way. Take it to an

authorized service center.

Do not disassemble charger; take it to an authorized service

 

center when service or repair is required. Incorrect reassembly may

5

result in a risk of electric shock, electrocution or fire.

Page 5
Image 5
Black & Decker LHT2436B, LHT2436R manual important safety instructions for battery chargers