Black & Decker LST300R Important Safety Instructions For Battery Packs, Save These Instructions

•	An extension cord must have adequate
		Volts			Minimum Gauge for Cord Sets
	wire size (AWG or American Wire Gauge)				Total Length of Cord in Feet
	for safety. The smaller the gauge number	120V			0-25	26-50	51-100	101-150
	of the wire, the greater the capacity of the	240V			0-50	51-100 101-200		201-300
	cable, that is 16 gauge has more capacity	Ampere Rating				Not more
	than 18 gauge. When using more than one	More
	extension to make up the total length, be	American Wire Gauge						Than
	sure each individual extension contains at	Than
•	least the minimum wire size.	0	-	6	18	16	16	14
	Do not place any object on top of	6	-	10	18	16	14	12
	charger or place the charger on a soft	10 -		12	16	16	14	12
	surface that might block the ventilation	12 -		16	14	12	Not Recommended
	slots and result in excessive internal
	heat. Place the charger in a position away from any heat source. The charger is
•	ventilated through slots in the top and the bottom of the housing.
	Do not mount charger on wall or permanently affix charger to any surface. The charger
•	is intended to use on a flat, stable surface (i.e., table top, bench top).
	Do not operate charger with damaged cord or plug — have them replaced immediately.
•	Do not operate charger if it has received a sharp blow, been dropped, or otherwise
•	damaged in any way. Take it to an authorized service center.
	Do not disassemble charger; take it to an authorized service center when service or repair
•	is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.
	Disconnect the charger from the outlet before attempting any cleaning. This will reduce
•	the risk of electric shock. Removing the battery pack will not reduce this risk.
	NEVER attempt to connect 2 chargers together.
•	The charger is designed to operate on standard household electrical power (120 Volts).
	Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY PACKS

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

• Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

• If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

• Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

• Charge the battery packs only in Black & Decker chargers.

• DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

• Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer). WARNING: Never attempt to open the battery pack for any reason. If battery pack case is

cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

6