ASSEMBLY INSTRUCTIONS
BEFORE ASSEMBLING YOUR MOWER, CHECK THAT YOU HAVE RECEIVED THE FOLLOWING IN THE SHIPPING CARTON.
SEE FIGURE 1.
A. Mower |
| D. Discharge Chute |
B. Upper Handle | E. Plastic Bag with 2 handle bolt and | |
C. Lower Handle | 2 cable ties | |
1 | A | C |
|
|
E
D
B
ASSEMBLING THE HANDLE (FIGURE 2A)
1.Your mower carton contains the mower, 2 handles, discharge chute and 1 plastic parts bag.
2.Fasten the upper and lower handle halves together using the eye bolts (already installed on the power and flip cords) and the handle knobs from the plastic bag. Make sure the power cord and switch are on the same side of the mower as the discharge area and that the flip locking mechanism is on the opposite side. There are three holes on the upper handle, this allows the handle height to be set in three positions. Choose the hole that best suits your overall height. Install the eye bolts to the outside of the handles so that the knobs are on the inside. Tighten the knobs securely.
2A
ATTACHING THE HANDLE (FIGURE 2B)
1.UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.
2.Brace the front end of the mower so that it cannot roll forward.
3.Align the ends of the lower handle vertically over the flip bracket installation slots with the power cord on the same side as the discharge area. (Figure 2B)
4.Spread the handle sightly and push the handle down until they engage on the flip brackets, taking care not to pinch or damage the power or flip cord.
5.Pull up on the handles to ensure a secure fit.
6.Install cable ties, from plastic bag, in locations shown on lower handle.
2B
REMOVING THE HANDLE (FIGURE 3)
1.UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.
2.Brace the front rear of the mower so that it cannot roll backward.
3.Pull the handle release lever and rotate the handle to a vertical position.
4.Grasp the ends of the lower handle with both hands. Pull the two sides of the handle apart while pulling up on the handle. Be careful not to damage cords when removing handle
WARNING: NEVER use a sharp object to move jacketed wires out of the way.
3
2
1
MULCHING
The mower is designed to mulch or discharge the grass depending on whether mulch door is closed (mulching) or the mulch door is up and the discharge chute is in place (discharging). No further assembly steps are required if you are mulching. PROCEED TO OPERATING INSTRUCTIONS.
DISCHARGE CHUTE INSTALLATION (FIGURE 4)
(If you wish to discharge the clippings rather than mulch, perform these steps)
1.UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE STOP.
2.Open mulch door by pulling on the mulch door finger grip. (Figure 4A)
3.Align the discharge chute arrows with the positioning arrows on the mower deck and insert the discharge chute as shown.
4.Position the chute until the chute hooks are trapped under the deck hooks and release the chute and door. (Figure 4B)
4
B
A
OPERATING INSTRUCTIONS
NOTE: A mower is a major appliance and should not be operated simultaneously with other major appliances on the same house circuit.
WARNING: Make sure that other persons and pets are at least 100 feet away.
INSPECT CUTTING AREA
Remove all rocks, sticks, wire, toys, bones, and other debris or items which might be thrown by the rotating blades.
4